lodge6

The Rondack Lodge
The Cabin...Finishing!

Design Copyright 2007, Steve Frederick

Frame

Exterior Walls, Body

I used a piano hinge to allow the potty cabinet to swing up.

I assembled the door on the bench, then took it into the cabin for final fit-up.

Here, Ive started the table. I held the side edges back 3/4" to allow the table to sit in the cleats at the front of the dinette seats.
The table will serve as the center section of the bed.

1/2" ply was used for the top. Pretty boring, so Phyll had an idea..

I looked around for scraps of ply that were left over from the rest of the project. Phyllis wanted a design, so I made a pattern from a scrap of luan.

Moving the pattern around and cutting with a router yielded parts for the design.

This is Cherry, Curly Maple and Sapele Mahagony.

I sealed the top in epoxy after gluing the sections to the 1/2" ply below.
I'll finish the table in polyurethane.

Phyllis made curtains! Here's the bed room!!

And here's the dining room!! You can see where the table will rest on the dinette seat edges.

The pattern is a mix of leaves found in the Adirondacks in the Fall.

Contents and images, Copyright, 2002-2007, Steve Frederick
No image or text may be reproduced for any commercial use without permission. Updated July 2, 2007
This design is Copyright, 2007, Steve Frederick

Back

Home